AORURA LED library, CLI, and emulator.

• Protocol
• Library
• CLI
• Emulator
• Hardware

AORURA communicates via a serial connection (19200n8). All commands it supports are exactly two bytes:

• XX turns the LED off
• A< puts the LED into its signature shimmering “aurora” state
• a color byte followed by ! makes the LED light up with the given color
• a color byte followed by * makes the LED flash with the given color at a half-second interval

AORURA responds to these commands with a single byte: Y if successful, N if not.

There’s one more: SS. AORURA responds to this command with two bytes representing the command for its current state.

AORURA’s initial state is B* (flashing blue).

Valid color bytes:

• B: blue
• G: green
• O: orange
• P: purple
• R: red
• Y: yellow

aorura is a library that implements the AORURA protocol.

use aorura::*;
use failure::*;

fn main() -> Fallible<()> {
  let mut led = Led::open("/dev/ttyUSB0")?;

  led.set(State::Flash(Color::Red))?;
  led.set(State::Off)?;

  assert_eq!(led.get()?, State::Off);
  assert_eq!(State::try_from(b"B*")?, State::Flash(Color::Blue));

  Ok(())
}

aorura-cli is a CLI built on top of the AORURA library.

Usage: aorura-cli <path> [--set STATE]
       aorura-cli --help

Gets/sets the AORURA LED state.

Options:
  --set STATE  set the LED to the given state

States: aurora, flash:COLOR, off, static:COLOR
Colors: blue, green, orange, purple, red, yellow

path=/dev/ttyUSB0
original_state=$(aorura-cli $path)

aorura-cli $path --set flash:yellow

# Do something time-consuming:
sleep 10

# Revert back to the original LED state:
aorura-cli $path --set "$original_state"

aorura-emu is a PTY-based AORURA emulator. It can be used with the library or the CLI in lieu of the hardware.

Usage: aorura-emu <path>
       aorura-emu --help

Emulates AORURA over a PTY symlinked to the given path.

• AORURA-3 (HoloPort and HoloPort+)

  

• AORURA-UART-1 (HoloPort Nano)